The device for galvanization and electrophoresis POTIK-01M is intended for the effect of direct current on the human body for therapeutic and prophylactic purposes, as well as for conducting medical electrophoresis in a clinic and hospital.
Technical specifications
|
Supply voltage, V
|
220
|
|
Frequency, Hz
|
50
|
|
Power consumption, W, no more
|
15
|
|
Maximum current in the patient circuit at
load 500 Ohm, mA
|
50 + 5
|
|
Current adjustment range, mA
|
0 - 50
0 - 5
|
|
The current ripple coefficient at any value of the load current, %, does not exceed
|
0.5
|
|
Weight, kg, no more
|
1.5
|
Delivery set:
|
Device POTIK-01M
|
1 pc.
|
|
Patient lead with tip
|
2 pcs.
|
|
Passport (operating manual)
|
1 pc.
|
A set of carbon fabric electrodes for electrotherapy devices.
Price: 1500.00 UAH.
Set of carbon fabric electrodes for electrotherapy devices (rectangular: 40x50mm-2pcs., 50x100mm-2pcs., 90x140mm-2pcs., 130x190mm-2pcs., Shcherbaku collar 250x440mm)
The electrodes are designed to work with various physiotherapy devices that use electric current as a medical effect (electrophoresis, galvanization, amplipulse therapy, etc.), and meet the requirements of all known treatment methods.
Each electrode consists of a multilayer cotton hydrophilic gasket (9 layers of white flannel) and a conductive layer of carbon fabric. The use of carbon material allows you to use 100% of the electrode area, while ensuring a uniform current density throughout the electrode. To improve drying conditions, each electrode consists of three interconnected hydrophilic packages. There is a special pocket for connecting the power supply on the outside of the electrode.
The resource of electrodes is 100 cycles of procedures. The average service life before write-off is 6 months. In this case, the intensity of operation is up to 2 cycles daily.
The electrodes can be washed and sterilized and disinfected by boiling in distilled water; drying can be either natural or in a drying cabinet, the recommended drying temperature is up to 85 degrees. To prolong service, the electrodes should not be left wet for a long time.
Before first use, the manufacturer recommends sterilizing the electrodes for 30 minutes.
Instructions for use:
To carry out the procedure you need:
- connect the two-layer electrode with the white hydrophilic side to the additional hydrophilic gasket, preventing the electrode from protruding beyond the edges of the gasket;
- moisten with warm tap water or medication (for economy, it is recommended to moisten only the hydrophilic gasket with the medication);
- apply the electrode to the patient's body area (with the white side directly to the patient's body);
- fix the gaskets on the patient's body using an elastic bandage or any other traditional method;
-Connect the conductive clamps to the electrode's current-dissipating layer.
CAUTION: Do not allow the electrode's current-dissipating layer (gray) or the metal parts of the conductive clamps to touch the patient's body.
